How to properly prepare for temporary fence installation in Minneapolis

With massive construction going on in Minneapolis, MN, it is critical that temporary fences are used properly for workers and pedestrian safety. Having installed thousands of temporary construction fences in Minneapolis and surrounding Minnesota communities such as La Vista, our crews have sat idle at many job sites while the contractor frantically tries to figure out where to put his construction fence. We have also gone back to just as many job sites and relocated the temporary site fence due to a lack of preparation. This is not how you want to start any new project. Before our crews to get to your site, please consider some easy preparation.

In preparing for temporary fencing in Minneapolis, start with:

1. Stake the location of your Minneapolis temporary fence
   1. Locate your property line. We have watched hundreds of job site superintendents scratch their heads as they try to figure-out where the property line is located.
   2. Be aware of any setbacks or easements. Any new construction project is going to involve relocating or connecting to utilities. Setting your Minneapolis temporary fence in the utility easement is a surefire way to guarantee having to relocate it.
   3. Be aware of blocking visibility at intersections and City codes prohibiting obstructions at intersections. No one wants to watch a pile-up from their job site trailer. Blocking visibility of oncoming traffic at an intersection can be a very dangerous act.
   4. Consider contractor access to the site for equipment and materials. Most materials delivered to the site will be via a flat bed tractor trailer. These trucks are almost 85 feet long and require half that amount for a turning radius. Allow these deliveries room to access the site.
   5. Consider storage of onsite materials. Contractors will deliver truckloads of sand, blocks, brick, insulation, red iron, roofing, etc. You should consider the storage of all this material beyond the limits of construction. No one wants to pay to move materials around the site.
   6. Consider contractor parking. If you want contractors to show-up to work; you have to allow them a place to park. When you force your work force to park outside the site; you often block deliveries, etc. You will spend more time as a traffic cop than you may want to.
   7. Consider site conditions that may not allow the fence to be kept tight to the ground. What good is a construction temporary fence in Minneapolis if you allow areas for others to crawl under the fence.
   8. Consider placing the fence next to any structures that would allow ease of climbing the fence. Installing the fence tight against transformers, signage, stored materials, etc. is inviting others to climb in or shuffle materials out.

1. Stake the location of gates for temporary fencing in Minneapolis
   1. Consider codes and traffic laws regarding egress and ingress relative to intersections and busy streets. City officials study ingress and egress to any new project. This also applies to construction access. Installing a temporary construction gate in Minneapolis, in close proximity to an intersection, is a recipe for an accident.
   2. Do you need jurisdictional approval for these access points? Temporary site access approval may be required during the permitting process. Don’t forget to ask.
   3. Consider equipment and material deliveries with large tractor trailers. Large tractors and trailers cannot turn into construction sites where the gate is set tight to the street or right next to an intersection.
   4. Consider worker arrivals and departures. Hopefully, your subcontractors show-up to work. When they do, don’t create a traffic jam by using the same gate for deliveries.
2. Clear the site. Be sure the site is clear of any vegetation, equipment, materials, etc. An Minneapolis temporary fence is only useful if you make it visible and in-line of site of the general public. Install your Minneapolis temporary fence in shoulder height weeds and you are allowing thieves the time and cover to access your fence.

– Todd LaVigne
President
American Fence Company